how to remove drivers seat vw t5 conversions

The standard bolts for the seat base are too long for the swivel base, so need to be cut down, I did this with an slitting disc on a 4.5″ grinder, the instructions say to leave about 14mm of thread. The wires were soldered together and then covered in two layers of heat shrink tubing just to be sure and a temporary fuse box has been located under the drivers seat, eventually these fuses will be incorporated into the new fuse box with all the other electrics that we will be adding.

Luckily there were two seasoned professionals on hand to do the soldering. Luckily on the T5 there are lots of places to hide the wires, and after untangling and tidying, we laid them in a trough under the rubber mat, we then set about extend the wires for the fuses. The seat is held in with bolts, these are easily removed, the wiring connectors arena two plastic chassis bolted to the seat from, unbolt these and the seat can be lifted away to reveal the wiring. Some people like to hide these under the new swivel base, however we do not want to be removing the seat if we have to change a blown fuse, so we will extend the wiring for these to under the drivers seat. The base appears to be well made and is quiteheavy, in order to fit it we need to first remove the passenger seat, however VW like to use the space under here to connect up parts of the loom and add fuse boxes.

This one has quick release fixings and has been M1 tested for safety, I don’t imagine the testing is as rigorous as for a new vehicle, but it gives some peace of mind about carrying passengers. This entails the fitting of a swivel seat base, there are a few of these on the market, of varying designs, and we chose the one from Custom Shop Designs. In order to to enjoy family a la carte dining while away, we need to be able to swivel the passenger seat around to face rearwards, so that we can all sit round the table.

How to remove drivers seat vw t5 conversions